Flyzone FLZA6400 - Manual (Page 3)

™
CHECK THE CONTROL SURFACE
DIRECTION CENTER THE CONTROL SURFACES
Because the AirCore Module can be used in more than one
plane, we recommend making sure the control surfaces
are as close to center as possible on each plane. Make
sure the trims are centered on your transmitter.
Check that the elevator and rudder are centered on the
airplane. If they are not, use needle nose pliers to gently
squeeze or spread the “U” bend in the pushrods to center
the control surfaces.
INSTALL THE PROPELLER
CAUTION: Do not install the propeller until the plane is
ready to fl y. Once the battery is connected, the motor
will start if the throttle stick is moved up.
Disconnect the battery and snap the propeller onto the
propeller adapter.