FloAire STEAM COIL - Manual (Page 3)

STEAM IOM
1
Guidelines for the installation, operation and maintenance of Heatcraft’s steam heating coils have
been provided to help insure the proper performance of the coils and their longevity. These are
general guidelines, which may have to be tailored to meet the specific requirements of any one job.
As always, a qualified party or individual should perform the installation and maintenance of any
coil. Protective equipment such as safety glasses, steel toe boots and gloves are recommended
during the installation and routine maintenance of the coil. Caution! Steam, even at low pressure,
can cause serious bodily injury that may result in death. Be sure the system is off or the components
are isolated before beginning work.
Receiving Instructions
1. All Heatcraft coils are factory tested, inspected and carefully packaged.
2. Damage to the coils can occur after they have left the factory. Therefore, the coils
should be inspected for shipping damage upon receipt. The freight bill should also be
checked against items received for complete delivery.
3. Damaged and/or missing items should be noted on the carrier’s freight bill and signed by
the driver.
4. For additional assistance, contact your local Heatcraft representative.
5 SA 12 01 C 24.00 x 110.00
Tube O.D. Finned Length (inches)
8=1”
5=5/8”
Fin Height (inches)
Coil Type Fin Design
5SA : single tube, opposite end connection A - flat (Al, Cu)
5JA,8JA: distributing tube, same end connection B - corrugated (Al, Cu)
5DA,8DA: distributing tube, dual supply, C - sine wave (Al, Cu)
opposite end connection F - flat (SS, CS, Al, Cu)
8RA: distributing tube, opposite end connection G - corrugated (SS, CS, Al,
Cu)
5HA:
high-pressure construction H - sine wave (SS, CS, Al, Cu)
single tube, opposite end connection
5GA,8GA: high-pressure construction
distributing tube, same end connection Rows Deep
5LA,8LA: high-pressure construction, distributing
tube, dual supply, opposite end connection
8TA: high-pressure construction Fins Per Inch
distributing tube, opposite end connection
5SB: single tube, 3” center to center
opposite end connection
Nomenclature