Fieldmann FDB 2005-E User Manual

Page 19

MULTI FUNCTION TOOL

OPERATING INSTRUCTIONS

Cutting a hole in wood flooring to install a heating vent

Fig. 8

3. Place the saw blade (2) near the floor surface in the middle of one of the cutting lines.
4. Set the tool speed at a medium speed and turn the tool ON (Fig. 5 & 6)

NOTE: The tool and blade should be at a 45° angle to the floor to allow the corner of the blade to plunge
cut into the flooring.

5. While holding the tool tightly, slowly plunge the corner of the blade into the flooring until it cuts through the

flooring. Once the plunge cut is complete, set the tool to its highest speed and complete the cut to the corner
of the rectangle.

6. Turn the saw OFF, remover it from the cut and proceed to cut in the opposite direction to complete the cut for

the first side of the rectangle.

7. Repeat steps #4, #5, #6 to cut the remaining three sides of the rectangle.
8. When all cuts are complete, use a flat blade screw driver to carefully pry the cut-out from the floor.

NOTE: Do NOT use the saw blade to pry the cut-out from the floor. You will break the blade. If the cut-out s
not easy to pry from the floor, check to make sure each line is cut completely into the corner of the rectangle.