3 on/off switch, 4 speed control wheel – Fieldmann FDB 2005-E User Manual
Page 16

EN
16
FDB 2005-E
ON/OFF switch | Speed control wheel
5.3 ON/OFF SWITCH
To turn the too ON, slide the ON/OFF switch (1) toward the front of the tool (Fig. 5).
To turn the tool OFF, slide the ON/OFF switch toward the rear of the tool.
Fig. 5
5.4 SPEED CONTROL WHEEL
The speed of the tool can be adjusted to run the tool at speeds varying between 10000 – 18000 RPM by rotating
the speed control wheel (1) located towards the rear of the tool housing (Fig. 6)
To increase the speed, rotate the speed control wheel toward the left side of the tool.
To decrease the speed, rotate the speed control wheel toward the right side of the tool.
Fig. 6
POZNÁMKA: Speed #1 is the lowest speed. MAX is the highest speed. The optimal speed setting will vary
depending upon the type of accessory being used, the surface being worked and the complexity of the
project. For general recommendations, se the chart on the following page.