Fieldmann FDB 2005-E User Manual

Page 14

Text mode
Original mode

FDB 2005-E

Installing accessories

2. Place the blade (5) on the accessory holder (Fig. 2)

Fig. 2

NOTES:

Make sure the alignment holes (6) in the blade fit over the alignment pins (7) in the accessory holder and the

printed side of the blade is facing the tool.

The blade can be mounted at various angles left or right of center if required.

3. Thread the screw (1) through the washer (2) and the blade into the accessory holder threaded hole (8)
4. Turn the screw clockwise until it is finger tight.

NOTES: Check to make sure the convex curve or the washer (9) is facing the head of the screw. Make
sure the alignment holes in the blade are still mated with the alignment pins in the accessory holder

5. Firmly tighten the screw with the 5mm hex key.

NOTE: Check to make sure the holes in the blade are still mated with the alignment pins of the accessory
holder after the screw is fully tightened.