Emerson Radio CKD9917 - Manual (Page 12)

11
Listening To the Radio
1.) Press the ALARM OFF/POWER button on
the top panel to turn the unit ‘On’. The
POWER LED indicator will light.
2.) Press the RADIO/BAND button to select the
Radio function. Either the MHz or KHz
indicator will light to show which band is
selected. Press the RADIO/BAND button
again to repeatedly switch between the AM
and FM bands.
3.) Rotate the TUNING control on the right side
panel to tune to the desired station.
4.) Rotate the VOLUME control on the left side panel to adjust the volume level.
5.) If you tune to an FM stereo station, the STEREO (ST) indicator will light.
6.) When you are finished listening press the ALARM OFF/POWER button to
turn the unit ‘Off’ . The POWER LED indicator turns off.
Antenna Information
AM
The AM ferrite bar antenna is inside the cabinet. If AM reception is
unsatisfactory, try turning the entire unit slightly until you find the direction that
provides the best reception for the desired station.
FM
The FM antenna is built in to the AC power cord. If the FM reception is weak, try
varying the position and direction of the power cord until you find the strongest
signal.
AL2
MHz
KHz
MON TUE WED THU FRI SAT SUN
ST
CD AUX REP RAN PROG PLAY
SLP
AL1
AM
SAT
MHz
MON
ST
MON
AM
MHz
MON
ST
MHz
KHz
FM BAND
AM BAND
In Radio listening mode, the radio frequency display will appear for
approx. 3 seconds,then the clock time will appear on the display.
Press the ALARM SET / DISPLAY button to show the radio frequency, a few
seconds later the display will show the clock time.