Emerson Radio ES1065 - Manual (Page 21)

20
Listening To The Radio
1.) Press the STANDBY button to turn the system ‘On’.
The display lighting comes on and the display
shows “HELLO”.
2.) Press the TUNER/BAND button to select the Tuner function.
An AM or FM frequency will appear on the
display.
Press the TUNER/BAND button again to switch between the AM and FM bands
if necessary.
3.) Tune to the desired station as follows:
• Manual Tuning
Repeatedly press the or buttons until the display shows the exact
frequency of the desired station. Use the Manual Tuning method to tune to
weak or distant stations that are not strong enough to be recognized by the
Automatic Tuning system.
• Automatic Tuning
Depress and hold the or buttons until the display begins to move, then
release the buttons. The Tuner will search up or down the band for the next
strong signal and stop on that station. Repeat this procedure until the tuner
stops on your desired station.
4.) If you tuned to an FM Stereo station the
STEREO indicator will appear in the display.
If the FM Stereo reception is noisy or weak, press the ST/MONO button on
remote control to select the FM Mono mode.
5.) Adjust the VOLUME and EQ controls to the desired settings.
6.) When you are finished listening press the STANDBY button to return the
system to the Standby (Off) mode. The display lighting goes off and the display
changes from radio frequency to correct time.
ES1065_021705.p65 17/2/2005, 15:41 20