Optional accessories, Operating instructions – EDCO SK-10 User Manual
Page 7
E-MPS-I-0612
Printed in USA
TVW
©2012
Page 7
100 Thomas Johnson Drive, Frederick, MD 21702-4600 USA
Phone (301) 663-1600 • 1-800-638-3326
Fax (301) 663-1607 • 1-800-447-3326
Website: www.edcoinc.com
Email: [email protected]
Optional Accessories
Optional Water Tank Kit for
SK-14 (P/N 52030),
SB-14 (P/N 51090),
DS-18 (P/N 56310)
Model SK-14, with WaterTank Option, shown
•
TO STOP THE MACHINE: Stop forward motion. On gasoline models push the throttle to idle. Turn the
depth control handwheel knob counter clockwise to raise the blade clear of the cut. Turn ignition or power
switch off and let the engine come to a complete stop. Turn off the water supply.
•
WHEN MANEUVERING THE SAW: Make sure the blade is raised high enough so it does not strike the
slab surface. Damage to blade may occur with inadvertent contact with the slab or other object.
•
DO NOT FORCE BLADE WHILE CUTTING.
•
IF THE POWER SOURCE STALLS IN THE CUT: Raise the blade completely out of the cut. Disconnect
the power source (i.e. the spark plug wire on a gasoline engine or disconnect an electric model at the ma-
chine). Inspect the blade flange nut/bolt to verify that they are still tight, and inspect the blade for damage.
Replace damaged (or questionable) blades immediately.
•
WHEN TRANSPORTING THE SAW: Be sure to remove the blade. Before removing the blade, disconnect
the power source before lifting or removing any guard. See the directions for Changing Blades on
(page 9)
.
•
WHEN HOISTING A CONCRETE SAW EQUIPPED WITH A LIFTING BAIL: Always inspect frame and
attaching hardware for damage
before lifting. Use proper safe hoisting techniques and hardware.
Figure 7
Operating Instructions