EDCO ALR-BS - Manual (Page 6)

Printed in USA
©2006
TVW
Page 6
E-ALRE-I-0706
100 Thomas Johnson Drive, Frederick, MD 21702-4600 USA
Phone (301) 663-1600 • 1-800-638-3326
Fax (301) 663-1607 • 1-800-447-3326
Website: www.edcoinc.com • Email: [email protected]
PROCEDURE FOR INSTALLING AND REMOVING A CHISEL
Remove the air supply before performing the following steps. To install a chisel,
there are several different types but all install in the same manner. Slide the collar
back towards the chisel holder and slide the chisel hex end into the chisel holder
and release the collar to lock the chisel in place. Be sure the chisel is seated all
the way into the chisel holder.
Pictured above shows the chisel installed. To remove a chisel reverse the above procedure and
pull the chisel out of the chisel holder.
Chisel Holder
X
Collar