EDCO CPU-10FC - Manual (Page 12)

Printed in USA
©2005
TVW
Page
E-CPU10FC-I-0905
100 Thomas Johnson Drive, Frederick, MD 21702-4600 USA
Phone (301) 663-1600 • 1-800-638-3326
Fax (301) 663-1607 • 1-800-447-3326
Website: www.edcoinc.com • Email: [email protected]
Never work on or under equipment without first securing the equipment to prevent it from mov-
ing or falling. Always work on a flat and level surface.
Refer to the Engine Manufacturer’s Owner’s Manual
for maintenance information specific to the engine used.
Grease cutter assembly bearings (2)
after every 4 hours of use.
IMPORTANT!
• Grease Depth Control Bearing every 40 hours.
• Check hydrostatic transmission fluid level after
every 50 hours of operation. If it is low, fill to
level mark with GM Dexron B or comparable
fluid.
Grease wheel bearings every 40 hours
Remove both spark plug leads on gasoline engine models or
disconnect the supply voltage connector on
electric models before performing any maintenance.
Disconnect the power cord at the machine.
Maintenance Instructions
Cutter Assembly
Bearings (2)
Depth
Control
Bearing
Transmission
Fluid