Operating instructions, Important reminder – EDCO TG-10 User Manual
Page 5
E-TG10-I-0612.3
Printed in USA
TVW
©2012
Page 5
100 Thomas Johnson Drive, Frederick, MD 21702-4600 USA
Phone (301) 663-1600 • 1-800-638-3326
Fax (301) 663-1607 • 1-800-447-3326
Website: www.edcoinc.com
Email: [email protected]
Figure 2
Before Operating:
•
Visually inspect machine:
- Verify all guards are in place and fasteners are tight.
- Check engine oil level (gasoline/propane models).
- Inspect power cord for damage and check for proper grounding (electric models).
•
Inspect disc assembly:
- Check discs for damage or wear.
- Check mounting hardware.
- Check belt tension after fi rst 4 hours of use with factory new equipment or after installing new belts.
•
Inspect the work area:
Inspect work area carefully before starting to grind. EDCO will not be held responsible for damage to the discs
caused by striking protruding slab inserts, nails, screws, pipe extensions, machinery bases, or other objects that
transmit sudden shocks.
Safety warnings and guidelines do not by themselves eliminate danger.
They are not given as substitutes for proper accident prevention and good judgement.
Operating Instructions
Exhaust from this engine contains Carbon Monoxide, an invisible,
odorless gas that can kill. In addition, it contains chemicals known, in cer-
tain quantities, to cause cancer, birth defects or other reproductive harm.
Important Reminder!
A water mist system or an industrial vacuum must be used while operating this equipment and the
operator must wear a respirator. Failure to comply could lead to serious illness and possible death.
•
If dry grinding:
- Hook up heavy-duty vacuum.
•
If wet grinding:
- Attach hose to water supply.
- NOTE: Do not use dry vacuum when wet
grinding.