EDCO TG-10 - Manual (Page 10)

E-TG10-I-0612.3
Printed in USA
©2012
TVW
Page 10
100 Thomas Johnson Drive, Frederick, MD 21702-4600 USA
Phone (301) 663-1600 • 1-800-638-3326
Fax (301) 663-1607 • 1-800-447-3326
Website: www.edcoinc.com
Email: [email protected]
Belts:
To remove/replace belts:
• Remove belt cover to expose belts. (Figure 13)
• Loosen engine/motor mounting bolts (Figure 14) on both sides of the TG-10 and slide engine forward to allow
belts to slide off.
• Replace worn belts with a complete set of new belts - even if only one belt is showing wear.
• Slide engine back in place until belts are tight and retighten engine mounting bolts.
• Reinstall belt cover and tighten hardware.
• After four hours of use, retighten belts.
Figure 15
Engine Air Filter:
Inspect the air fi lters (Figure 15) for excess dust, dirt
or damage before the engine is operated. More often if
operating in a dusty environment.
Operating the engine with a damaged or dirty air fi lter,
or without an air fi lter, will allow dirt to enter the engine
causing rapid engine wear which would not be covered
under the engine manufacturer’s warranty.
Follow the engine manufacturer’s procedures for keep-
ing the fi lters in good condition.
Figure 13 Figure 14