Ecler MPAGE16 User Manual
Page 6
6
c.
The microphone balanced audio signal (MIC +, MIC-, GND) should be
connected to one of the 8 MIMO88 audio inputs (IN 1 to IN 8)
Power can be supplied directly from MIMO88 through pins 1 and 2 of the remote devices
bus connector. In some cases, it will be necessary to use WPPSU optional 15V AC-DC adapter to
meet consumption requirements of the setup, depending on the number of MPAGE16 and / or
WPtouch devices installed and on the wiring type and length. If this external power supply is used, it
must be connected between + DC and GND for the console and the DC + terminal must not be
connected to MIMO88. If in doubt, contact our technical support.
2.
Touch keys sensitivity adjustment (optional).
MPAGE16 touch keys sensitivity has two possible settings, depending on the
TOUCH SENSITIVITY jumper position inside the unit:
x
HIGH: default position, with TOUCH SENSITIVITY jumper in place
x
LOW: TOUCH SENSITIVITY jumper removed
+DC
GND
CAN H
MIC +
CAN L
MIC
-
NETWORK LED
TOUCH
SENSITIVITY
LOW
HIGH (DEFAULT)
JUMPER
(1)
(2)
(3)
(6)
(5)
(4)
(1)
(6)
3. Programming and implementation of the MIMO88-MPAGE16 set from EclerNet
Manager application