Ecler MPA 6-80R - Manual (Page 11)

11
3.7. Output options
OPTION MPA4-80R MPA6-80R
1 mono 4 mono amplifiers 6 mono amplifiers
2 stereo 2 stereo amplifiers 3 stereo amplifiers
3 bridged 2 bridged amplifiers 3 bridged amplifiers
4 combination 1 bridged amplifier and 2 mono amplifiers
for a common mono input
1 bridged amplifier and 4 mono amplifiers for a
common mono input
5 combination 1 bridged amplifier and 1 stereo
amplifiers for 2 different stereo amplifiers
1 bridged amplifier and 2 stereo amplifiers for
3 different stereo amplifiers
WARNING: The output TERMINALS, marked with this symbol are HAZARDOUS LIVE
terminals.
The external wiring connected to these TERMINALS must be installed by an INSTRUCTED
PERSON or using ready made leads or cords.
4. OPERATION AND USAGE
4.1. Start up
To switch the unit on just push the switch labelled POWER (19) and the integrated pilot-light will
light up. We highly recommend the "safe power-up sequence": First the sound sources, then mixer,
equalizers and active filters and, finally, power amplifiers. Powering off should be done by following the
exact reverse sequence in order to avoid any possible peaks reaching the next device, and
consequently protecting the loudspeakers, which are specially sensitive to these peaks.
NOTE: Fully disconnecting the device from mains is done unplugging the power cord from the
mains input socket (50). For this reason, it always shall remain readily operable.
MPA4-80R
N. ACTIVE VOL CH 1 CH 2 CH 3 CH 4
1 CH1,2,3,4 + - + - + - + -
2 CH1,2,3,4 + - + - + - + -
3 CH1,3 + BRIDGED - + BRIDGED -
4 CH1,3,4 + BRIDGED - + - + -
5 CH1,3,4 + BRIDGED - + - + -
MPA6-80R
N. ACTIVE VOL CH 1 CH 2 CH 3 CH 4 CH 5 CH 6
1 CH1,2,3,4,5,6 + - + - + - + - + - + -
2 CH1,2,3,4,5,6 + - + - + - + - + - + -
3 CH1,3,5 + BRIDGED - + BRIDGED - + BRIDGED -
4 CH1,3,4,5,6 + BRIDGED - + - + - + - + -
5 CH1,3,4,5,6 + BRIDGED - + - + - + - + -