Ecler CA120 User Manual
Page 10
10
ON/STBY: the green light comes on when the equipment is in normal operating
mode and it goes orange when it is in standby or low consumption mode
(STANDBY).
LEVEL: This flashes when you adjust the general level of the device. It also lights
up during special adjustment modes, input levels (see section 4.2. Special active
source selection mode and setting adjustments)
BASS: This lights up during special adjustment modes bass frequencies (see
section 4.2. Special active source selection mode and setting adjustments)
TREBLE: This lights up during special adjustment modes, treble frequencies (see
section 4.2. Special active source selection mode and setting adjustments)
LINE1, LINE2, LINE3/MIC: These light up during special modes, selection of
active sources and adjustments (see section 4.2. Special active source
selection mode and setting adjustments)
4.5. Micro switches on the rear panel
REMOTE: Turn on (ON) the remote control from the WPmVOL or WPmVOL-SR wall
panel connected to the REMOTE port.
NOISE GATE: Turn on (ON) or turn off the noise gate function for the LINE3/MIC
input. When this function is active the microphone input is muted whilst there is no
signal above the function activation threshold, so the equipment rejects background
noise captured by the microphone connected to it.
TALKOVER: On or off according to the priority of the LINE3/MIC input over the line
inputs (LINE1 or LINE2). When the TALKOVER function is on, the LINE3/MIC
signal will attenuate the selected line (LINE 1 or 2) when the activation threshold
set is reached.
AUTO STANDBY: Switch the AUTO STANDBY function on (ON) or off. When the
function is on, the CA120 will automatically go into STANDBY or low consumption
mode in the absence of audio signals in its inputs.
STEREO / MONO (ST/MONO): Select the work mode of the amplified outputs of the
unit:
o
ST: Work in stereo mode L / R
o
MONO: Work in MONO mode, both channels amplifying the L+R signal.