DVIGear DVI-3420a - Manual (Page 9)

-7-
5 .2 Setup Example
If you select the first item on the main menu, Picture Adjust, a secondary menu
will provide the following selections:
Brightness
Contrast
Color
Tint
H. Peaking Filter
Sharpness
V. Peaking Gain
Reset
Exit
For example, if you want to change the Color level, use the + / – buttons to
navigate to this item on the Menu, then press the Menu button again to select
that option. When Color is selected, a sub-menu for the adjustment will appear:
Color 25
Use the + and - buttons to increase or decrease the value of the setting. Press
Menu again to leave the setting. Move the cursor to select
Exit and press Menu
again to Exit.
5 .3 Display Setup
When this menu choice is selected, a sub-menu will appear that allows the
selection of the scaler’s output resolution (see Section 2.1). Use the + and –
buttons to choose the desired PC or HDTV output resolution from the available
selections.
5 .4 Advance Setup
Advance Setup allows you to turn off the Film Mode (3:2 Pull Down), turn off
the OSD (On-Screen Display) and set the “No Signal” Display to either a Blue or
Black screen.
5 .5 System Information
When selected, the OSD shows the unit’s current Input Mode, Output Resolution
and Vertical Refresh Rate.