DVIGear DVI-7435 - Manual

DVI-7435
EDID Manager /
DVI + HDCP 1x2 Splitter Quick Start Guide
Introduction
The DVI-7435 is a high-performance 1x2 DVI splitter with built-in EDID Management. The unit
supports DVI and HDMI 1.3a signals with or without HDCP encryption. It automatically compensates
for DVI copper cables with lengths up to 60 meters (~200 ft.) without the need for user adjustment.
The output signal is stabilized using Pixel Accurate Re-clocking technology, which removes jitter
caused by long cables or poor quality signal sources.
Using Advanced EDID Management, the DVI-7435 can emulate any DVI / HDMI display for continuous
video output, even if the attached display is disconnected or powered off. 100 EDID memories are
provided. EDID memories from 01 to 50 are factory preset and memories from 51 to 98 are user
programmable. Memory 00 is transparent for Output 1 and Memory 99 is transparent for Output
2, which means that the attached display device’s EDID (monitor or projector) will be reported to
the source. Using DVIGear’s Easy EDID Creator (PC) software, users can create their own EDID by
completing four simple steps. More experienced users can use DVIGear’s Advanced EDID Editor
software to manage all settings within the EDID structure and then upload to the DVI-7435 via the
unit’s USB interface.
Typical Application
DVI-7435 EDID Manager / DVI + HDCP 1x2 Splitter
1
USB cable
Control Laptop
HD Projector
DVIGear SHR™
DVI cable up to 60 m.
DVIGear SHR™ DVI cables
DVI-7435
+5 VDC
Power Adapter
Monitor Blu-ray or DVD Player