DVIGear DVI-23xx-FO - Manual (Page 10)

-8-
5 .3 Optional Flexible Protective Boot for Tx and/or Rx Modules
The DVI-2300-CVR is a flexible boot cover that provides additional protection
during installation, moving or storage. To secure the boot to a transmitter or
receiver module, first slip the cover snugly over the module. Next, wrap the
flexible attachment arm around the cable and create a loop. Pull the end of
the attachment arm through the provided hole past the attachment point.
6 .0 TROUBLESHOOTING
If the system fails to display an image, power OFF all devices and verify
the following:
1. The transmitter module must be connected to the Source device. The
receiver module must be connected to the Display.
2. Confirm there is power to the Fiber Optic Cable. The transmitter module
must receive adequate power in order to function. In the event that the
source device cannot provide sufficient power, the transmitter may be
powered by an External AC Power Adapter (see page 7).
3. Once all connections have been verified, power ON the monitor first, then any
intermediate equipment, such as switchers, and finally the source device.
4. If the system still fails to display an image, confirm that the fiber cable was
not damaged during installation.
5. If the system still fails to display an image, check to ensure that the signal
source is compatible with the display by making a direct connection
between the two with a short cable so as to bypass the DVI / HDMI Fiber
Optic Cable. If there is still no image, then there is a compatibility issue
between the source and the display that must be resolved.
If the problem persists after trying the above suggestions, please contact your
dealer for additional assistance. If the dealer’s technical personnel are unable
to assist you, please contact DVIGear via telephone at 1.888.463.9927 (toll-free
for United States and Canada) or 1.770.421.6699. You may contact DVIGear by
e-mail at [email protected].