DVIGear DVI-7320 - Manual (Page 6)

-4-
4. PACKAGE CONTENTS
Before starting installation, please check the package contents:
• 1x DVI-7320-Tx Transmitter Unit
• 1x DVI-7320-Rx Receiver Unit
• 1x DVI-7320-PS External AC Power Adapter (5VDC, 2A)
• 1x User Guide
5. INSTALLATION AND OPERATION
This product consists of the DVI-7320-Tx Transmitter Unit and the DVI-7320-Rx
Receiver Unit. The DVI-7320-Tx must be connected to the DVI output port of the
signal source (such as a PC). The DVI-7320-Rx should be connected to the DVI
input port of a digital display.
DVI-7320-Tx
Front Panel
Back Panel
DVI-7320-Rx
Front Panel
Back Panel
The DVI signal components are routed from the DVI-7320-Tx to the DVI-7320-Rx via
two distinct signal paths: the low-speed signals are sent over a copper CAT5 cable
link, and the high-speed TMDS and clock signals are sent over seven (7) multi-mode
fiber optic cables with LC connectors (see the picture below).
Each unit has seven (7) Optical ports that are marked with the numbers T1, T2, T3,
T4, T5, T6, and T7 on the DVI-7320-Tx unit, and R1, R2, R3, R4, R5, R6, and R7
on the DVI-7320-Rx unit. It is important to connect each LC fiber optic cable to the
corresponding number on both the DVI-7320-Tx and DVI-7320-Rx units.