Dynaflite GPMA0510 Super Decathlon - Manual (Page 19)

19
❏ 6. Glue the die-cut 1/8" balsa top longeron and
die-cut 1/8" balsa bottom longeron to the fuse sides.
❏ 7. Glue the die-cut 1/8" ply rear fuse side to the
top and bottom longerons.
❏ 8. Remove the pins from the fuse side and cover
the fuse side with Plan Protector.
❏ 9. Align the second fuse side over the first and
pin it in place. Glue the longerons and the rear fuse
side in place, making the other fuse side assembly.
These assemblies are now known as fuse sides.
Note: It is very important that the fuse sides be the
same. Take your time aligning these pieces so that
the second fuse side matches the first.
❏ 10. Lift the left fuse side off the right side and lay
it down mirrored to the right fuse side. Write “left”
on the inside for clarity. Remove both fuse sides
from your work surface. Sand the glue joints
smooth on both sides of each fuse side.
❏ 11.Glue the die-cut 1/8" ply wing saddle doubler
and the two die-cut 1/8" balsa longeron doublers to
the inside of both fuse sides. Note: Make sure you
built a left and a right fuse side.
❏ 12. From the two leftover 1/4" x 1/4" balsa sticks
(from making the bulkheads) and two 1/4" x 1/4" x
30" balsa sticks, fit and glue the side stringers in
place.
19