D.A.S. Audio Aero 50 Rack - Manual (Page 8)

K-6 DSP amplifiers, presets will be named as follows:
A50Vx.y Low -Low
A50Vx.y Mid-High MT
A50Vx.y Mid-High LT
A50Vx.y Mid-High ST
Due to the configuration of the power supply of the amps, Powersoft warns that
both output channels must have a close to identical charge at output stage, since
unbalanced charge will cause problems of excessive temperature rise. We
recommend to follow next arrangement to the amplifier racks and cabling.
Each pack of 2 K6 DSP (LOW-LOW-MID-HIGH) is able to manage up to
4 Aero50 creating a 2 Ohm load configuration.
A50rack - 8
Since Armonía version 2.3.1, we are able to upload a preset directly from the software by right clicking on the desired amp.
This could be faster but it will not save the preset into the DSP memories.
In order to be able of changing between different types of throws provided by DAS Aero50v5.5 Presets, we recommend the
use of the PRESET MANAGER tab in armonía (A), using the PLST file (B) you can “broadcast” the whole preset family for
all connected amps by one single click (C).
Make sure you have muted or unplugged the whole system speakers before doing this, since after spreading
all presets the amps will take number 1 to use, being this one the LOW-LOW this can cause serious damage to high drivers.
WARNING: