D.A.S. Audio Aero 50 Rack - Manual (Page 4)

The family of presets available for the three main
different platforms (DAS DSP-2060A/4080,
PowerSoft K-6, Lake Lm26 / PLM) is based on a flat
frequency response of a single aero 50 cabinet. For
updates check the DAS Audio website (aero 50
related downloads).
For DAS DSP-2060A and 4080 the presets are
available in AudioCore .xaa format.
For the Powersoft K-6 DSP amplifiers presets are
available in Armonia format.
For the Lake LM26 /PLM amplifiers, presets are
available in .csm lake format.
Different High Pass X-overs for the LF are
provided; (a) 45Hz to be used as a full range
system without subs, and (b) with cut at 80Hz to be
used with LX-218C (or CA) subs.
Besides the High Pass X-overs presets are
available for long (LT), mid (MT)and short throw
(ST) zones in the array. To achieve a uniform sound
pressure level across the distance and optimal
acoustical performance a line array system has to
be managed in groups of cabinets with different
presets. For instance the four bottom cabinets
should have to be treated as the downfill or short
throw of the system.
There will be two different types of presets:
Type A: presets to be used in the rack processors
to define all the settings in one cabinet.
Presets for all these platforms: DSP-2060A, LM26
and K6DSP.
Presets will be named as follows:
A50Vx.y LT
A50Vx.y MT
A50Vx.y ST
For instance: A50V5.4 ST
www.dasaudio.com/en/p/aero-50-2/
http://www.dasaudio.com/DOCUMENTOS_D/SOFT
WARE/AUDIOCORE_V871.ZIP
http://www.powersoft-
audio.com/en/support/armonia-support-
forum.html
http://labgruppen.com/support/software_firmware/
The presets
A50rack - 4
preset version
preset version
Long, Mid or Short Throw
Number of Units
Type B: to be used at the FOH DSP-4080
processor. The preset will compensate the array effect
and the number of cabinets used.
These presets will be named as follows:
A50Vx.y 8U
A50Vx.y 10U
A50Vx.y 12U
For instance: A50V52 16U