D.A.S. Audio Action Series - Manual (Page 7)

7
action 215A
-2-way powered system
-2 x 15" bass loudspeaker
-Compression driver with titanium diaphragm
-Two steel-reinforced handles
The action 215A is a powered loudspeaker (2
channel Class D amplifier), that utilizes two 15”
bass loudspeakers for extra low frequency punch
and higher SPL. High frequencies are handled by a
1” compression driver with titanium diaphragm. The
trapezoidal cabinet is constructed using Birch
plywood and protected with a hard-wearing black
paint finish. Two bar handles and a steel grille
sealed against corrosion using a polyamide powder
coat finish are provided. Rigging points provide a
safe and simple way to fly the
action 215A cabinets.
action 18A
-Bass-reflex powered subwoofer system
-18" low frequency transducer
-Precise and powerful bass reproduction
-Top located pole mount socket
The action 18A bass powered system (Class D
amplifier) incorporates a 18” low frequency
transducer with a 4 " voice coil mounted as a
direct radiator into a bass-reflex cabinet. The
loudspeaker is protected by a perforated steel
grille, sealed against corrosion using a powder
coat finish. The
action 18A is designed for use in
biamped systems. A top located pole-mount
socket permits mounting full-range systems above
the
action 18A and two bar handles makes moving
easy.
action 218A
-High output bass-reflex powered subwoofer
system
-Twin 18" loudspeakers
-Durable black paint finish
-Side located bar handles
This bass-reflex powered subwoofer system
uses dual 18" bass loudspeakers equipped with 4"
voice coils. The exceptional power handling
capacity and efficiency provide high sound
pressure levels of powerful bass. Two hand
locations facilitate handling. The cabinet is
designed to be stacked in the vertical position in
order to reduce the units "on-stage" footprint.
Manual del Usuario / action active / User’s Manual
action 15A
-Two-way powered system
-15” bass loudspeaker
-Compression driver with titanium diaphragm
-Asymmetric enclosure design for stage monitor use
-Built-in rigging points (eyebolt bassed)
-Stand mountable
Action 15A is a powered loudspeaker (2 channel Class D
amplifier), uses a 15” low frequency transducer and a 1” exit
compression driver with titanium diaphragm. The cabinet is
constructed from Birch plywood and finished with an
envinonmentally friendly black paint finish. Two bar handles are
provided and a steel grille protects components. A 35mm tripod
socket allows for stand mounting. Rigging points provide a safe
and simple solution for suspending the
action15A