CLIFFORD Arrow 5.1 - Manual (Page 22)

19 © 2 0 0 6 d i re c t e d e l e c t ro n i c s
smart power up II
This security system will store its current state to non-volatile memory.
If power is lost and then reconnected the system will recall the stored
state from memory. This means if the unit is in Valet Mode and the bat-
tery is disconnected for any reason, such as servicing the car, when the
battery is reconnected the unit will still be in Valet Mode. This applies
to all states of the system including arm, disarm, and Valet Mode.
power saver mode
Your system will automatically enter Power Saver Mode while armed or
in Valet Mode, after a period of time in which no operation has been
performed. This lowers the current draw on the vehicle's battery and
prevents the system from draining the battery. Power Saver Mode takes
over under the following conditions:
z Power Saver when the system is armed: After the system has
been armed for 48 hours, the LED will flash at half its nor-
mal rate, decreasing the system's current draw.
z Power Saver in Valet Mode: When the system enters Valet
Mode the LED illuminates steadily. If the vehicle is not used
(ignition is not turned on) for a period of one hour while the
system is in Valet Mode, the LED will shut off. If the system
remains in Valet Mode, the LED will come back on the next
time the ignition is turned on and then back off.