CLIFFORD Arrow 5.1 - Manual (Page 15)

12
To enter Valet Mode:
1. Turn the ignition on.
2. Enter PIN code (factory setting is 2).
3. After the last digit continue to hold for
three seconds.
The LED status indicator will light steadily if you are entering Valet
Mode and will turn off if you are exiting Valet Mode.
To exit Valet Mode:
1. Turn the ignition on.
2. Within 10-seconds press once.
transmitter valet mode
The operations described in this section refer to transmitter buttons.
Remember, the buttons used in all the instructions in this guide corre-
spond to a Standard Configuration transmitter. This may not be how
your transmitter is set up.
To enter Valet Mode, press and simultaneously. The LED
nnoottee:: The pin code can be entered after turning the ignition On and the press
and hold the blank key on the PlainView 2 Valet switch for one second.