Disarming without a transmitter, Remote siren silencing, Transmitter chirp muting – CLIFFORD Arrow 5.1 User Manual

Page 12

disarming without a transmitter

This feature allows you to disarm the system without the transmitter

should it be lost, damaged, or disabled. In order to disarm without a

transmitter, you must have the vehicle’s ignition key, know where the

PlainView 2 Valet switch is located, and have the PIN code. Be sure to

check with the installer for the location of the PlainView 2 Valet switch

and instructions for entering the PIN code. Turn the ignition On and

then press the

button twice (factory PIN default setting) and the

button once to disarm without a transmitter.

remote siren silencing

This system offers remote siren silencing. Remote siren silencing is a fea-

ture that makes it possible to silence and reset the system when it is

triggering without disarming the system. If the system is triggered and

the siren has been sounding, press

on the transmitter to stop the

trigger and return the unit to the armed state. The system will not dis-

arm, but rather reset. This prevents you from disabling the system

should you wish to silence it without visually checking the vehicle. After

resetting the system, press

again to disarm the system.

transmitter chirp muting

To temporarily turn off the arm or disarm chirps, use transmitter chirp

muting. Simply press

and

simultaneously on the trans-

mitter, and the confirmation chirp(s) will be eliminated for that one op-

eration only. The parking lights will flash to confirm the arm/disarm

command. If you want the arm/disarm chirps turned off permanently,

please refer to the User-Selectable Features section of this guide.