D.A.S. Audio WR Systems User Manual

Page 17

PROBLEM

1 - No sound from any units.

2 NO sound from one unit.

–

3 Poor stereo image or weak bass

–

output

CAUSE

1.1 – No signal present in the
amplifier

1.2 – Defective cable.

1,3 – High number of speakers
connected in the same amplifier’s
channel.

2.1 – No signal present in the UNIT..

3.1 – Wrong connection

SOLUTION

1.1.1 – Check that the amplifier is
on.
1.1.2 – Check that the gain is set
above its minimum setting.
1.1.3 – Check that there is a signal
to your amplifier from your mixer.

1.2.1 – Check that the cable from
the sound source to the UNIT is
connected correctly. Replace the
cable if defective.
1.2.2 – Check that none of the
connected cables are cut or frayed.

1,3,1 – Check the minimum
impedance requirements of your
amplifier.

2.1.1 – Check that the cable
between the UNITS is connected
correctly. Replace the cable if
defective.
2.1.2 – Check the balance control
on the mixer.

3.1.1 – Check the polarities (+/-) and
be sure that all the speakers are well
connected.

Manual del Usuario

/ WR series / User’s Manual

TROUBLESHOOTING