Comtrol UP 16-Port - Manual (Page 29)

DeviceMaster UP 16-Port Hardware User Guide: 2000596 Rev. B Managing the DeviceMaster UP - 29
Managing the DeviceMaster UP
This section discusses the following DeviceMaster UP maintenance procedures:
• Rebooting the DeviceMaster UP
• Uploading Firmware to Multiple DeviceMaster UPs on Page 30
• Configuring Multiple DeviceMaster UPs Network Addresses on Page 31
Note: You can configure the network addresses for multiple DeviceMaster
UPs, configure common settings for the DeviceMaster UPs, and save the
settings to a configuration file that you can use to load settings up to all
or selected DeviceMaster UPs.
• Adding a New Device in PortVision DX on Page 31
• Using Configuration Files on Page 33
• .Managing Bootloader on Page 35, which also discusses checking the
Bootloader version and downloading the latest Bootloader
• Accessing RedBoot Commands in Telnet/SSH Sessions (PortVision DX) on
Page 37
Note: You can optionally refer to RedBoot Procedures on Page 41 if you want to
perform procedures at the RedBoot level.
Rebooting the DeviceMaster UP
There are many ways to reboot the DeviceMaster UP.
Method Procedure
PortVision DX
Right-click the DeviceMaster UP or DeviceMaster UPs in the
Device List pane, click Advanced >Reboot and then Yes.
Note: If security has been enabled in the web page, you will
need to reboot the DeviceMaster UP in the web page.
Web page
Main page (Server Status): Scroll to the bottom of the page,
click Reboot and then Yes: Reboot.
Telnet Type reset.