COMEUP Compact Winch (Ver:00) - Manual (Page 12)

10
Wire Rope Replacement
● Insert the wire rope into the hole of drum and fix it with a P. T. screw, then press the ↑ button
of switch for rotate the drum in the lifting direction.
● Wind the wire rope accurately around the drum, and an irregular winding will cause the load
to be swing, thus damaging the wire and reducing the life of winch.
● When replacing, according to the following procedures.
* Pull out an R-dowel "D" from the round head pin "C".
* Pull out a round head pin "Cc from hook body "A".
* Put a wire rope "B" into the hole of hook body "A", and insert a round head pin "C" through
wire rope and fixture hole of hook body "A".
* Insert an R-dower "D" into the hole of round head pin "C".
Carbon Brush Replacement
● It is essential to check the carbon brush periodically. If its length is left less than 7.5 mm
resulting from wear, it is absolute necessary to replace carbon brush immediately.
● While replacing, smoothly insert carbon brush into carbon holder in the first place, then put
brush cap into the hole.
● Before tightening the carbon brush holder, make sure to position O-ring.
● A set of carbon brush consists 2 piece of carbon brush. Ascertain to replace 2 pieces of
carbon brush on opposite sides of winch body at the
Lifting direction Wire rope
Wire drum
！
WARNING
Clean the accumulated powder of carbon brush periodically to ascertain the
insulation resistance up to 1MΩ.
Brush cap