Clippasafe 112 Extendable No Trip Gate - Manual (Page 2)

LOW PRESSURE MOUNTING
WITH SCREW FIXED HINGES
AND WALL CATCHES
This gate is suitable for openings
between 61cm (24in) and 109cm (43in)
wide.
1. Measure the with of the opening
where you wish to place the gate in.
2. Adjust the two gate sections to one
of the eight lettered positions A-G,
according to the size of the opening.
3. Align the holes on both gate sections.
Secure the gate sections together by
fastening 2 x screws (1) into 2 x
screws (2) on the top bar of the gate
and 2 x screws (1) into 2 x screws (2)
on the bottom bar of the gate.
WARNING - INCORRECT FITTING OR
POSITIONING OF THIS SAFETY BARRIER
CAN BE DANGEROUS
The gate must be fitted in a structurally
solid opening, free of dirt and grease.
The position of the safety barrier in relation
to the stairs may have an adverse affect on
your child’s safety:
- If the barrier is used at the top of the
stairs to prevent your child from falling
down the stairs, it must not be placed on
any stair below the level of the top stair.
- If the safety barrier is used at the
bottom of the stairs to prevent your
child from climbing up the stairs, it must
be placed on the lowest stair.
This product requires the purchase
of appropriate fixing aids suitable
for the surface to which the hinges
and catches are to be fitted.
2
2
1
1
A B C D E F
1 2 3 4 5 6
X
X = 61 68 cm
X = 68 74 cm
X = 74 81 cm
X = 81 89 cm
X = 89 95 cm
X = 95 102 cm
X = 102 109 cm
+ A
A
A
B
C
D
E
3
2
1
+
+
+
+
+
+
1
1
1
1
+ D
E
F
F
F
F
F
6
6
6
+
+
+
+
+
+
5
4
3
2