Chrysler 2015 200 - User Guide - Manual (Page 32)

Rear Head Restraints
The rear outboard head restraints have three positions Up, Mid and Down. The center head
restraint has only two positions, Up and Down. When the center seat is being occupied the head
restraint should be in the raised position. When there are no occupants in the center seat the head
restraint can be lowered for maximum visibility for the driver.
To raise the head restraint, pull upward on the head restraint. To lower the head restraint, press the
push button, located at the base of the head restraint, and push downward on the head restraint.
NOTE:
To remove the head restraint, raise it as far as it can go then push the release button and the
adjustment button at the base of each post while pulling the head restraint up. To reinstall the
head restraint, put the head restraint posts into the holes and push downward. Then adjust the
head restraint to the appropriate height.
WARNING!
ALL the head restraints MUST be reinstalled in the vehicle to properly protect the occupants.
Follow the re-installation instructions above prior to operating the vehicle or occupying a seat.
FRONT SEATS
Power Seats
The power seat switches are located on the outboard side of the front seat cushions.
The power seat switch controls forward, rearward, up and down adjustments.
The recline switch controls the angle of the
seatback.
• Press the switch forward or rearward and the
seatback will move in either direction.
The power lumbar switch controls the amount
of lumbar support needed.
• Push the switch forward to increase the lum-
bar support.
• Push the switch rearward to decrease the
lumbar support.
• Pushing upward or downward on the switch
will raise and lower the position of the
support.
Power Seat Switches
1 — Power Seat Switch
2 — Recline Switch
3 — Power Lumbar Switch
G E T T I N G S TA R T E D
30