Universal garage door opener (homelink®), Before you begin programming homelink, Programming a rolling code – Chrysler 2015 300 - User Guide User Manual

Page 127: Universal garage door opener, Homelink®)

UNIVERSAL GARAGE DOOR OPENER

(HomeLink®)

• HomeLink® replaces up to three hand-held transmitters that operate devices such as garage

door openers, motorized gates, lighting or home security systems. The HomeLink® unit is

• The HomeLink® buttons that are located in the overhead console or sunvisor designate the

three different HomeLink® channels.

• The HomeLink® indicator is located above the center button.

Before You Begin Programming

HomeLink®

Ensure that your vehicle is parked outside of

the garage before you begin programming.
For efficient programming and accurate trans-

mission of the radio-frequency signal, it is rec-

ommended that a new battery be placed in the

hand-held transmitter of the device that is be-

ing programmed to the HomeLink® system.
To erase the channels, place the ignition switch

into the ON/RUN position, then push and hold

the two outside HomeLink® buttons (I and III) for up to 20 seconds or until the red indicator

flashes.
NOTE:

Erasing all channels should only be performed when programming HomeLink® for the first time.

Do not erase channels when programming additional buttons.
If you have any problems, or require assistance, please call toll-free 1-800-355-3515 or, on the

Internet at HomeLink.com for information or assistance.

Programming A Rolling Code

NOTE:

For programming Garage Door Openers that were manufactured after 1995. These Garage

Door Openers can be identified by the “LEARN” or “TRAIN” button located where the hanging

antenna is attached to the Garage Door Opener. It is NOT the button that is normally used to

open and close the door. The name and color of the button may vary by manufacturer.
1. Place the ignition switch into the ON/RUN position.
2. Place the hand-held transmitter 1 to 3 inches (3 to 8 cm) away from the HomeLink® button you

wish to program while keeping the HomeLink® indicator light in view.

3. Push and hold the HomeLink® button you want to program while you push and hold the

hand-held transmitter button.

HomeLink® Buttons

E L E C T R O N I C S

125