Surround mode, Phones, Display messages – RCA RV-9978 User Manual
Page 9: Tuning the receiver, Tuning, Auto tuning, Storing stations in memory, Receiver controls & operations
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
RECEIVER CONTROLS & OPERATIONS
WIDE
The WIDE mode can be activated in both the Pro
Logic and the 3 Stereo modes. This mode utilizes
just the three front speakers - left main, right main
and center - with all audio delivered through the
center speaker. The center speaker
will reproduce the same bass levels as the left and
right main speakers.
SURROUND MODE
Included in the SURROUND MODE category are Dolby
Pro Logic, Dolby 3 Stereo, Hall and Bypass.
DOLBY PRO LOGIC
The Pro Logic mode uses all five speakers so the
sound envelopes the room.
DOLBY 3 STEREO
The 3 Stereo mode uses the two main and one
center speaker.
HALL
The Hail mode recreates the effect of listening to a
concert or watching a play from inside a music
hall. It utilizes the main and surround speakers.
BYPASS
The Bypass mode utilizesjust the main speakers.
MASTER VOLUME
The Master Volume dial allows you to adjust the level
of audio output.
PHONES
The receiver has been equipped with a Phones jack.
Plug your headphones - not included - into the jack
and listen to your favorite media in private.
DISPLAY MESSAGES
The following is an example of all the display messages you may encounter while using your receiver. Specific
messages are referenced within the section(s) they apply.
TUNED STEREO
MUTE MEMORY
— CENTER MODE —
NORHN.WI£nWM?OH
FM
AM
il
n n n
u u.u n
u
MHz
kHz
BYPASS
AUTO
DEUY
TIME
REAR
CENTER
PRESET
n n
(J U ch
SPEW
TUNING THE RECEIVER
1, Push the FM/AM button on the receiver (or the
AM»FM button on the remote) to activate the
tuner.
2. Press the FM/AM button on the receiver (or the
AM*FM button on the remote) again to select the
FM or AM band.
TUNING
Press the FF on your remote button to move up the AM
or FM band.
Press the REW button on your remote to move down
the AM or FM band.
AUTO TUNING
Use the AUTO feature to automatically search for
stations of sufficient strength.
Press AUTO on your receiver (or the INPUT*SEEK
button on your remote) to put the receiver into AUTO
mode. "AUTO" appears in the display. Press TUNING
up or down button on the receiver to search. The tuner
finds and stops on the next station whose frequency is
strong enough to be received. To continue the search,
press TUNING up or down button again.
STORING STATIONS IN MEMORY
You can store up to 30 AM and FM stations. These
stations can be stored in random order.