Unpack the receiver, Basic connections, Unpack the receiver basic connections – RCA RV-9978 User Manual
Page 4: First things first
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
FIRST THINGS FIRST
UNPACK THE RECEIVER
Unpack the receiver and locate all the accessories. You
should have:
• one receiver unit;
• one RCA Universal Remote Control
(CRK67G);
• two packs - one pair each - of AAA batteries;
• one audio cable (two wires) with red and
white RCA connectors:
• one video cable (single wire) with yellow RCA
connectors;
• one external, detachable FM T-type antenna:
• one external AM loop antenna:
• one instruction book:
• one owner reg I strati on/survey card;
• and one safety leaflet.
video cable
remote
AM loop
audio cable
FM T-type antenna
BASIC CONNECTIONS
Assuming you have a VCR, the following steps will help
you quickly set up your new receiver. If you have more
electronic components, consult the table of contents or
index for the page on which to find the connection
description that best suits your situation.
*The wires and jacks have been color-coded to assist
you.
1. Using an audio wire with red and white
connectors, connect the audio "OUT" jack on the
back of your stereo VCR to the audio "IN" jack
under the VCR heading on the back of the receiver.
2. Using the video cable with yellow connectors,
connect the video "OUT" jack on the back of your
VCR to the "VIDEO IN" or "VIDEO INPUT" on the
back of your TV. If there are multiple video jacks
on the back of your TV, use "VIDEO 1."
NOTE: If your TV has more than one video input, make
sure the VCR and VIDEO buttons tune the TV to the
same channel that the receiver monitor out is plugged
into. Refer to the TV's user's guide for more
information.