Toshiba MA-120 Series - Manual (Page 12)

3) Holding the paper winding shaft, cut off the journal paper at the edge of the stamp table.
4) Remove the journal paper from the paper winding shaft.
NOTE:
1) To re-load the journal paper onto the paper winding shaft, pull out the remaining tip of journal paper
while pushing Paper Release Lever towards you.
2) When the printed journal paper is rolled up fully onto the paper winding shaft, the paper can no longer
be rolled up. In this case, cut off the printed paper according to above steps.
12. LOADING THE RECEIPT PAPER AND JOURNAL PAPER
New receipt paper and journal paper shall be loaded on the following steps.
1) When the receipt paper or journal paper runs out, cut off and take out the existing paper core.
2) Then, by depressing I feed I key, pull the receipt paper or journal paper tip remained out upward.
NOTE:
In case either one of the receipt paper tip or journal paper tip is taken out, use the paper free lever and pull it
out by hand.
3) Load a new receipt paper and journal paper into the paper holder. Tightly fold up the end of paper about 6
inches as illustrated below, insertt it along the paper inlet.
- 1 0 -