Denon DRW-585 - Manual (Page 11)

ENGLISH
PROPER RECORDING LEVEL
A too high recording level can saturate the tape and cause distortion.
On the other hand, if the recording level is set too low, soft passages
will be marked by residual noise. A proper recording level is the single
most important factor for making well balanced recordings. If the high frequencies (treble sounds) are to be boosted, turn the BIAS
FINE control counter-clockwise to decrease the bias current. Turn the
control clockwise to increase bias current.
By the use of this control, you can record tapes with a frequency
response that will perfectly match your listening taste.
Guideline for maximum recording level
TYPE I (Normal) 0 dB level on peaks
TYPE II (CrOjI - 1-1 dB level on peaks
TYPE IV (Metal) 1 3 dB level on peaks
Note: The optimum recording level differs depending on the program
source and the type of tape used,
RECORDING BIAS ADJUSTMENT
For best recording results, monitoring during recording and comparing
different recordings using your own judgement are essential.
The DEMON cassette deck is equipped with a BIAS FINE control to
assist you in setting the proper bias for different types and brands of
tape. At the center stop-click position, the deck is set to the reference
bias level for Normal, Cr 02 and Metal tape. If the resulting recording in
this position has too much or too little high frequency content,
adjusting the BIAS FINE control can be useful to achieve better results,
BIAS FINE
REC/REC MUTE AND REC PAUSE Button
To record a 5-second blank section during recording;
Press the REC/REC MUTE (•) button. A 5-second blank will be
recorded and the deck will enter the recording standby mode.
To record a 5-second blank section during the recording standby mode;
Press the REC/REC MUTE (•) button from the recording standby
mode. A 5 second blank will be recorded and the deck will enter the
recording standby mode again.
To cancel recording of blank space:
Press the REC PAUSE (II) button. Blank space recording will be
cancelled and the deck enters the recording standby mode.
To extend the blank section with another 5 seconds or more:
Simply press the REC/REC MUTE (•) button and the blank section will
be increased with another 5 seconds.
DIMMER ADJUSTMENT
With the DRW-585, the brightness of the display can be adjusted in
seven steps.
To make the display brighter, press the B deck's fast forward ( ►► )
button while holding in the B deck's STOP button.
To make the display dimmer, press the fast rewind ( ^ ) button while
holding in the STOP button.
The display is initially set to the maximum brightness.
11