Denon DRW-585 - Manual (Page 10)

ENGLISH
RECORDING (DECK B only)
Switch on your amplifier or receiver and the source component.
Set the Tape Monitor switch on your amplifier or receiver to the SOURCE position.
® Press the POWER switch to the ON ( ) position.
® Load the cassette tape.
(Check that the erasure prevention tabs of the cassette housing have
not been broken off.)
@ Move the DOLBY NR switch and select the Dolby NR type that suits the
recording. DOLBY NR
B OFF C
CiJ
Caution;
• Be careful not to erase important recordings by mistake. Inadvertent
start of recording will happen in the following cases:
1. If the PLAY button is pressed while the • indicator lights, recording
starts.
2. If the PLAY and REC/REC MUTE (•) button are pressed at the same
time, recording starts.
The best way to avoid accidental erasure is to break off the two erasure
prevention tabs on the cassette housing.
® Press the Direction button to select the direction of tape
transport,
® Select the type of tape transport with the REVERSE MODE switch.
Mode Switch position
To record on only one side
To continuously record
on both sides
CZD or RELAY
® Press the REC/REC MUTE (•) button to set the recording pause mode.
The indicator will light up.
@ Adjust the recording level with the INPUT LEVEL control while watching
the Peak Level Meter
® Press the PLAY button to start the recording.
The PLAY (0 or >) and the • indicator will light during recording.
® To pause the recording, press the REC PAUSE (II) button. Press the
PLAY button to resume recording.
(j$ To stop recording, press the stop ( ■ ) button.
10