Toshiba IK-643A - Manual (Page 9)

8. NOTES ON USE AND INSTALLATION
' Do not aim the camera at the sun
Do not aim the camera at the sun or point
it at the sun even if you are not shooting.
’ Do not shoot intense light
Intense light such as a spotlight may
cause a bloom or smear, A vertical stripe
may appear on the screen. However, this
is not a malfunction.
• Treat the camera with care
Do not drop the camera or subject it to
strong shock of vibration. Otherwise, the
camera may malfunction.
> Never touch internal parts
Do not touch the internal parts of the
camera other than the parts specified.
Otherwise, the camera may malfunction.
• Do not splash water on the camera
Install the camera where the camera can
be kept dry. If the camera gets wet, turn
off the power and contact your dealer.
• Install the camera
Where no video noise appears
If cables are wired near electric lighting
wires or a TV set, noise may appear in
images. In this event, relocate cables or
reinstall equipment.
• Check the ambient temperature and
humidity
Avoid using the camera where the
temperature is hotter or colder than
specified. Otherwise, the quality of images
may deteriorate or internal parts may be
affected. Special care is required to use
the
camera at high temperature and
humidity.
• Should you notice any trouble
If any trouble occurs while you are using
the camera, turn off the power and contact
your dealer. If you continue to use the
camera when there is something wrong
with it, the trouble may much worse and
an unpredictable accident may occur.
9. IN CASE OF PROBLEMS
Condition Check Points
No image
• Are the camera and connected equipments turned on?
• Is the iris of the lens adjusted properly?
• Are cables connected correctly?
Unnatural color • Is the monitor TV adjusted correctly?
• Is the lighting too weak?
10. CONFIGURATION
(1) Camera 1
(2) Accessories
(a) Lens Connector 1
(b) Instruction Manual 1
(c) Lens Cap 1
(d) Mount Base 1
(e) Screw 3
(E4-191J-100(M))