VTech 917ADX - Manual (Page 10)

S E U N I T F E A T U R E S O P E R A T I N G I N S I R U i ! T I O N S
REDIAL KEY
When you hear a dial tone, press this
key to redial the last phone number you
dialed on your 917 ADX.
INTERCOM (INT.COM) KEY , . ,
■ Press this key to initiate two-way, inter­
nal communication between the Base
Unit and Handset.
■ If the Handset is in the OFF mode, it will
ring a maximum of 4 times. The Hand­
set user can respond to the INTERCOM
ring by pressing 1NT.COM. The Handset
user can also choose to ignore the IN­
TERCOM ring, in which case, the ringing
will stop after 4 rings. Otherwise, the
Handset user can press OFF, which will
terminate the ringing.
I Press INT.COM to terminate INTERCOM
mode.
SPEAKERPHONE (SPKR) KEY ^ r
■ Press this key to use the SPEAKER­
PHONE for making or answering calls.
Press SPKR to end the call.
VOLUME UP KEY
VOLUME DOWN KEY
Press this key to decrease the Base Unit
speaker volume. A series of rapid beeps
tell you that minimum volume level has
been reached.
The volume level will continue to
increment down if this key is held down.
There are a total of 8 volume settings.
‘TONE KEY
From the PULSE (Rotary) dialing mode,
press this key to switch to TEMPORARY
TONE dialing mode.
When the call is ended, the phone will
return to PULSE dialing mode.
Press this key to increase the Base Unit
speaker volume. A series of rapid beeps
tell you that maximum volume level has
been reached.
The volume level will continue to incre­
ment up if this key is held down. There
are a total of 8 volume settings.
IMPORTANT: Whenever the Handset battery
pack is removed and then replaced, the Hand­
set must be reinitialized on the Base Unit cradle:
The Charge (CHR) LED on the Base Unit will
flash during the initialization. i (
MAKING CALLS
From the Handset
■ Pick up the Handset and press PHONE.
When you hear a dial tone, dial the number.
The IN USE LED (on the Base Unit) and
PHONE LED (on the Handset) will light.
■ If you make a mistake when dialing, press
OFF to hang up, then press PHONE to get a
dial tone again.
B You must always press PHONE before
you can dial a call on the Handset.
Disconnecting
I To end a call, either place the Handset
back in the Base Unit, or press OFF on the
Handset.
From the Speakerphone
■ The Base Unit also works as a Speaker­
phone. It allows you to make and receive
calls without using the Handset. You can use
the Speakerphone while the Handset is in or
out of the base.
■ Press SPKR on the Base Unit. You will
hear the dial tone over the speaker. Use the
Volume Control keys to adjust the speaker to
a comfortable listening level. Dial the number
on the keypad of the Base Unit. When the
party answers, speak toward the microphone,
located at the lower front edge of the Base
Unit.
■ To hang up, press SPKR again on the
Base Unit.
MAKING & RECIEVING
CALLS WnHOi;T USING
TRE HANDSET