Denon AVR-2500 - Manual (Page 12)

3-3 Remote Control Unit Learning Function
Use the [earning function to operate audio components manufactured by companies other than Denon and when your VCR or TV does not
operate with the preset memory function.
1, Press the USE/LEARN selector button with
the tip of a pen etc,, to set the learn mode.
Both the START and LEARNED/TX Indica­
tors flash,
2. Set the program switch to the side to be
"learned".
Set to the AUDIO side for the CD, tape deck
or OAT position, to the VIDEO side for the
CDP, VCR or TV position.
AVe/AVC VIDEO "•
Set the program switch to the position to be
"learned".
- GO oecK OAT
ЖЗ"
4. Set the remote control units so they are
facing each other, then press the button to
be "learned" on this unit's remote control
unit.
control unit
The indicator stops flashing and the START
LED lights.
The learnable buttons are the buttons which
can be operated with the OENON system
codes for the CD player, DAT and tape deck,
the buttons which can be operated with the
preset memory for the VCR, VDP and TV. For
the TV only, however, the buttons in the
section indicated "A" on the diagram above
can also be "learned". Use these to "learn"
TV channels.
5. Check that the START LEO is lit, then press
the button to be "learned" on the other
remote control unit.
6. Once the START LED turns off and the
LEARNEO/TX LED lights, release the button
on the other remote control unit.
The two LEDs start flashing again.
7. To "learn" other buttons, repeat steps 4 and
5.
8
. Once the learning operation is completed,
press the USE/LEARN selector button again.
The two LEDs stop flashing and the learning
mode is cancelled.
Check that the stored codes work properly.
9. For instructions on reset­
ting the "learned" codes,
refer to "clearing the Pre­
set Memory" on page 11,
—NOTES:------------------------------------------------------------------------------------------------------------
Up to 26 codes can be "learned", but this number may be lower if the codes are
long.
If a non-learnable button is pressed or two or more buttons are pressed at once,
the two LEDs will once again light when the button(s) Is released.
If the codes could not be stored, the LEARNED/TX LED does not light after the
START LEO turns off. (This may happen for a limited number of models.}
If the two LEDs start flashing rapidly after the START LED lights, this means that
the memory is already full, and the code you have just attempted to store was
not stored.
To "learn" that code, first perform the resetting operation.
12