Changing the security codes – Kenwood EM 618 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Press [Select] then press or
until "PIN Entry During Power Up"
appears with ^e current setting.
A Press [Disable] or [Enable] to change
^ the status.
‘Enter PIN* will appear
■D
T*a«rt
PIN Entry
During Power Up
Disabled
Enter PIN.
OK* wUt appear after you enter
4
dtgtts
J
Press [OK].
‘PIN Entry has been disabled* or ‘PIN Entry has been
enabled* will appear.
‘Changing the Security Codes
Follow the instructions below to change PIN. PIN2, artd/or the Handsel coda
Press [Menu].
2
3
Press CZ!> or until "Change Security
Settings" appears.
Press [Select], then press CS or
until "Change Secunty Codes" appears.
4a
To change PIN;
Press [Select].
‘Change PIN* appears only if ‘PIN Entry During Power Up*
is enabled.
4b
To change PIN2 or the Handset code;
Press [Select], then press or
until "Change PIN2" or "Change
Handset Code" appears.
Press [Select]*
‘Enter PIN*. ‘Enter PIN2*. or ‘Enter Handset Code* will of^joar
5
6
appear oflw you enter 4 digits
Enter PIN, PIN2, or the Handset code.
J
If
^ Press[OK].
‘Enter New PIN*. ‘Enter New PIN2*. or ‘Enter Now Handset
Code* wilt appear.
Enter New PIN
r.«tsi
71