beautypg.com

Installation antenna, Attachment qf handstrap, Attachment of belt suspender – Uniden UH-055 User Manual

Page 3: Selcall

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

INSTALLATION

ANTENNA

Since the maximum allowable power output of the transmitter is limited by the D.O.C., the

antenna is a very important factor affecting transmission 'distance. It is for this reason that
we strongly recommended that you install only a qaaiity^ntenna in your new citizens band
system. You have just purchased a superi^ transceiver. Don’t diminish its performance
by installing an inferior antenna.

*

Only a properly matched antenna system will allow maximum power transfer from the 50-
ohm transmission line tolfie ^diating element. Your Uniden dealer is qualified to assist

you in the selection'of the prt^>цr antenna to meet your application requirements.

ATTACHMENT QF HANDSTRAP

.A mounting hqle is i>rovided above the PTT switch on the left of the unit. If you wish to use

the handstrap, apply the tip of the metal ring of the strap to this hole and attach by rotating

k. Se&the

illustration below.

^ •

ATTACHMENT OF BELT SUSPENDER

If you wish to use a belt suspender, attach it with the 2 screws provided on the rear panel as
illustrated below.

Belt

Suspender

SELCALL

SELCALL (Selective Calling) is a special Squelch System which quiets your receiver until
it receives an Encoded signal from another set which matches the one installed in your set.

This means your set will remain quiet and not receive idle chit chat or other signals until the

station you want to hear calls.

SELCALL is not initially installed in your set (each one has to be individually programmed)

but may be purchased as an option.

-

3

-