Reinstalling channels into the scan group, Servicing your transceiver, Preventive maintenance – Uniden UH-055 User Manual

Page 10: Operator troubleshooting

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

The selected channel has now been removed from the scan group and will not be included
when scanning has commenced and the ME will not be indicated on that channel.

Continue steps 3 and 4 to remove any other channels you do not wish to scan,

REINSTALLING CHANNELS INTO THE SCAN GROUP

To reinstall previously deleted channels into the scan group, simply repeat steps 3 and 4.

However, this time note that there will be a BEEP heard when the MEM switch is pressed,

and the ME will be indicated on the CHANNEL indicator, showing the selected channel is

now included in the scan group.

When you have finished, rotate the channel switch and notice that the ME is indicating on
the CHANNEL indicator which channels are programmed and which have been removed.

SERVICING YOUR TRANSCEIVER

The technical information, diagrams and charts will be supplied upon request.

It is the user's responsibility to see that this radio is operating at all times in accordance with

the D.O.C. Citizens Radio Service regulations.
We highly recommend that you consult a qualified radiotelephone technician for the ser
vicing and alignment of this UHF CB radio product.

Please refer to the WARNING information contained in the 1 st page of this Owner’s Manu

al.
(NOTE: When ordering parts, it is essential to specify the correct model number and serial

number of the unit.)

PREVENTIVE MAINTENANCE

At six to twelve month intervals, the following system checks should be made:

1. Check Standing Wave Ratio (SWR).

OPERATOR TROUBLESHOOTING

Should the unit malfunction or not perform properly, the operator should perform the

procedures indicated below;

1. If the transceiver is completely inoperative.

Check the battery.

2. If trouble is experienced with receiving,

Check OFF/VOLUME control setting.

Be sure SQUELCH is adjusted properly, is the radio over-squelched?

‘ Check to see that the radio is switched to an operational mode.

3. If trouble is experienced with transmitting.

Check to see that the antenna is securely connected to the ANTENNA CONNEC
TOR

{