Uniden CT301 - Manual (Page 12)

Using Your CT301
Dialing a Number
To dial a number with your CT301, first remove
the Handset from the cradle. Next, press the
TALK button. The ВАТТ LO LED will then light.
Dial the number normally, using the number
buttons on the Handset. When done talking, you
can press the TALK button again to hang up, or
simply place the Handset back in the cradle.
Using the R (Redial) Button
The R button dials the last number (up to 32
digits) that you called. This feature is extremely
useful when the number you called is busy. To
use this feature, simply press the R button imme­
diately after pressing the TALK button to select
the Talk mode. The last number called will then be
dialed again.
Note: If any button is pressed before the R
button, it will not redial. The R button must be
pressed immediately after selecting the Talk
mode with the TALK key.
Answering Incoming Calls
To answer an incoming call when the Handset is
off the cradle, press the TALK button and use the
Handset in a normal manner.
Using the Auto Talk Function
When your CT301 is ringing with an incoming call,
simply remove the Handset from the cradle to
answer the call; there’s no need to press the
TALK button.
Using the Auto-Standby Function
When you have finished with a call, placing the
Handset back on the cradle automatically causes
the Handset to go into Standby mode, and hangs
up the phone. There’s no need to press the TALK
button to hang up.
- 1 2 -