Bose RoomMate II - Manual (Page 3)

produce heat. Avoid placing ihe
system in direct sunlight.
9. Power sources. The RoomMate U
system is available for connection to
AC lines (mains) of various voltages.
If your unit has a line voltage selector
switch on the back, make sure the
selector is in the correct setting, e.g.
setto 115VforU.S. and230Vfor
Europe.
The RoomMate II can also be con­
nected to 12V DC voltage sources
such as the rechargeable Bose PC-1
powercase battery designed for use
with this system, as well as automo-
K/o or marine power sources. Ob-
\rvc the connections to the
source. Note: For portable applica­
tions, the RoomMate II system should
be used only with ffie Bose PC-1
powercase.
10. Power cord protection. Route
the power supply (mains) cord so that
it will rtot be walked on. cut, or
pinched by items placed upon or
against it. Pay particular attention to
cord at plug, and at the point where it
connects with the RoomMate II
system.
11. Non-use periods. If the
RoomMate II system is not going to
be used for any length of time, unplug
it from the wall outlet. Always unplug
the unit by grasping the plug itself.
Never pull the plug out by the cord.
Also, if the system is connected to the
battery or other DC power source and
is not going to be used for several
hours or more, unplug the system
from the DC power source.
?2. Object and liquid entry. Take
care that objects do not fall and
liquids do not spill into the enclosure
of the RoomMate II system through
the openings.
13. Cleaning/care and mainte­
nance. The RoomMate II system
requires very little maintenance.
Occasional cleaning should be done
with a damp cloth WHILE THE
SYSTEM IS UNPLUGGED. Never use
any chemicals to clean your system,
and never allow any liquids to enter
the unit’s openings.
14. Use with other systems. Do not
connect either the POWERED
speaker or the COMPANION speaker
to any other manufacturer's system.
15. Servicing. Never attempt to
service the RoomMate II system
yourself. There are no user service­
able parts inside. Refer all servicing to
qualified personnel.
16. Damage requiring service.
Have your RoomMate II system
services by qualified service person­
nel when any of the following occur:
A. The power supply cord or plug
has been damaged.
B. Objects have fallen onto or
liquid has spilled into the
enclosure.
C. The RoomMate II system has
been exposed to rain.
D. The system does not appear to
operate normally or shows a
marked change in perform-
manee.
E. The RoomMate II system has
been dropped or the enclo­
sure damaged.
ATTENTION
This unit ts equipped with a polanzed
alternating current fíne plug (a plug havHTg
one blade wider than the other). Tlvs plug will
fit into the power outlet only one way. This is a
safety (eaiure. if you are unable to insert the
plug fully into the outlet, try reversing lite plug.
If ihe plug sivx/fd still fail to fH. coniaci your
electrician to replace your obsolete oullei.
Do noi defeat the safety purpose of the
polarized plug.