Location, Cleaning, Repairs – Uniden UBC220XLT User Manual

Page 25

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

6, Insert the Battery

Pack into the scanner

so the label side is
showing. Make sure
it is seated within the
case before replacing

the Battery Cover.

7. Replace the Battery

Cover by putting the

two tabs in the

corresponding
opening and sliding it

upward until it locks in
place.

Location

■

If strong interference or electrical noise is received,

relocate the scanner or its antenna away from the

source of the noise. A higher elevation, if possible, may

provide better reception.

■

Do not use the scanner in high-moisture environments

such as the kitchen or bathroom.

■

Avoid placing the unit in direct sunlight or near heating
elements or vents.

Cleaning

■ Disconnect the AC Adaptor/Charger and/ remove the

battery from the unit before cleaning.

■

Clean the outside of the scanner with a mild detergent.

■

To prevent scratches, do not use abrasive cleaners or
solvents. Be careful not to rub the LCD window.

■

Do not use excessive amounts of water.

Repairs

Do not attempt any repair, The scanner contains no
serviceable parts. Contact the Uniden Technical Service
Division or take it to a qualified repair technician.