Setup, Charging the battery pack, Mounting the flexible antenna – Uniden UBC220XLT User Manual

Page 12

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Setup

The use 220XLT comes with a rechargeable Nickel
Cadmium Battery Pack. When hilly charged, this Battery will

supply up to 12 hours of dependable use. (With the Squelch
control in “ciosed” position.)

Before using the UBC 220XLT for the first time, or whenever

the LOW BATTERY Indicator appears on the LCD display,
you should fully charge the Battery Pack.

Note: When the Battery Pack is low, the Low Battery
Indicator

win

start to blink. After about 10 minutes, the

scanner wilt shut itself off to prevent the battery from

becoming completely discharged.

Before charging, you must first install the Battery Pack

according to the steps below.

Charging the Battery Pack

1. Plug the AC Adaptor/Changer (AAD-2500U) into the

Charging Jack located on the Left side of the
UBC 220XLT. You can use the scanner while It is
charging.)

WARNINGI Use only the suppled AAD-2500U

AC Adaptor/Charger (or one of the optional

Cigarette Lighter Power Cords listed on page 26).

Any other AC adaptor or external power plug
having over-voltage or reversed polarity can
cause overheating or damage to the dreuitry.

2. Plug the AC Adaptor/Charger into a standard AC outlet.

To fully charge the battery, leave the Adaptor/Charger
connected for 14 to 16 hours.

When charging is complete, disconnect the Adaptor/

Charger from the AC outlet and from the Battery Pack.

Note: Disconnect the AC Adaptor/Charger ñom the unit

during a power /aiure.

Mounting the Flexible Antenna

Place the end of the antenna onto the BNC connector on top
of the scanner and turn clockwise until tight.