Belt clip instaiiation, Recharging the nickel-cadmium battery pack, Do not – Uniden UH-056 User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Recharging the Nickel-Cadmium Battery Pack
Mote: Before charging, be sure that the power (ON/OFF
Volume control) is turned OFF.
Recharge the Ni-Cd Battery ONLY when the unit
indicates a LOW BATTERY condition.
(TX LED blinks during TRANSMIT)
Insert the discharged Battery Pack in the rapid charger, or
connect the trickle charger to the side of the unit.
Using the trickle charger, the standard pack charges fully in
8 hours, and the heavy duty pack in 12 hours. If you have a
rapid charger, the standard pack charges fully in 1.5 hours,
and the heavy duty pack charges fully in 2 hours,
DO NOT
leave the Batteries on charger for an extended
period of time.
Belt Clip Instaiiation
Place the Belt Clip on the
mounting area on the back of
the radio, making sure the
holes in the clip line up with
the threads in the back of the
radio.
Insert the 2 screws into the
corresponding holes and
tighten.
Balt Clip
® ©
loa DUM ilMEWi WlQB
CKTJr AM OC€
□ □ □ □
CAUTION:
DO NOT tighten the screws too tight, you could damage the
case.
UH-056
Page 10