Uniden DS70 - Manual (Page 18)

w
o
tc;
pu,
w
D
O
QUICK REFERENCE CHART
If your phone is not petforming to your expectations, please try these simple steps
first before calling Uniden customer service -
PROBLEM SUGGESTION
No dial tone Check that ±e phone line cord connectors at both ends
are pushed in until they dick.
If you have had a power failure or have unplugged the
base unit, replace the handset on the base unit for two
to five seconds to reset the system.
Does not ring You may have exceeded the limit of the number of
phones that can be conneaed to the same line, at the
one time
Themaxirnum is3.
No power on the
handset Check the battery pack connection inside the battery
compartment of the handset.
The handset rechatgable Ni-MH battery pack may need
to be chatged.
Does not charge Make sure the chargir^ contacts on both the handset
and the base unit are in contact during charging.
The charging contaas may need to be cleaned with an
alcohol-moistened cloth.
The battery pack may need to be dischaiged first before
a full charge can be accomplished.
Range is limited Make sure the base antenna is vertical.
Move the base unit so that it is centrally located in your
residence or office and make sure that the base unit is
not located near appliances.
Calls received,
flutter or fade
The handset rechatgable battery pack may need charging.
You may be out of normal operating rai^e. Move closer
to the base unit.
Cannot store or
recall phone
numbers from
memory
When storing phone numers, make sure that the handset
is in the standby position.
When recalling stored numbers, check first for a dial
tone.
17