Uniden DS70 - Manual (Page 15)

A
AUSTRALIA
The Call Walt+2 call waiting
procedure to^es betvfeen the
incoming and onginal call
(and visa versa).
The Call Wait + 1 procedure
will drop the current call
connection and pick up the
incoming call on hold.
A
NEW ZEALAND
You need to subscibe to
Telecom's Qll W aiting
Service before you can use this
feature.
14
CALL WAITING
▼ For Australian Version
Using the Call Wait feature
If the Call Waiting tone sounds, press Call Wait then 2 to accept the
waiting call (Aust. only).
-OR­
To return to the original caller press Call Wait then 1 (Aust.only).
T For New Zealand Version
Using the Call Wait feature
If the Call Waiting tone sounds during a call, press Call Wait to
toggle between the incoming call and the original call,
To locate the handset press Page on the Base Unit, The handset beeps
for about 15 seconds.
TRAVELLING OUT OF RANGE
As you begin to move too far from the base, you will first hear a clicking
sound. As you travel further, the noise increases. If you travel
out of range, your cal! terminates.
PABX CONNECTION
The DS70 telephone may work with a 2-wire Analogue PABX network.
However, with the DS70 hook-flash timing fixed at lOOms (NZ 600ms),
some PABX equipment that uses a different hook flash timing may have its
special feature (i.e. placing a call on hold or transferring a call) inaccessible.